If You Want to Build A Private Swimming Pool By Yourself
Architectural methods:
1. Cement bottom, glue wall structure, vinyl base material bottom pad.
2. The walls of the pool can be assembled by huge prefabricated pieces of various materials. The swimming pool manufacturer can use aluminium alloy, galvanized steel, plastic, FRP and other materials to build the wall.
3. Before starting construction, we must think of all the problems and have corresponding solutions. For example:
a. The location of the swimming pool.
b. What is the area of the swimming pool that can be resettled?
c. Think about how deep the pool is.
4. How to design the deck of the swimming pool above the ground?
5. Excavation should go beyond the planned boundary and be deep enough.
6. Prepare the three views of the swimming pool, prefabricate the wall structure, and design the location map of the wall installation.
7. Start the installation of pool wall components, do a good job of leveling the bottom of the pool.
8. The water supply, drainage and circulation pipes should be embedded in advance.
9. Prepare concrete, concrete backfill.
10. Build the bottom of the swimming pool (pay attention to smoothness and cleanliness), pay attention to the protection of various pre-embedded pipelines.
11. The masonry works as continuously as possible. Do not stop for more than 24 hours.
12. After completion of masonry, lay vinyl liner (when laying vinyl liner, pay attention to mutual cooperation, do not tear the liner).
13. At any time, the vinyl pad in place is fixed at the edge of the pool to prevent slippage, repeated procedures, increase the possibility of tearing the vinyl pad.
14. After paving, the vinyl pad should be carefully treated so that it can be compacted to the bottom of the concrete pool, and the air between the vinyl pad and the bottom of the concrete pool can be pumped out by a vacuum pump to completely fix the vinyl pad.
15. A cover is set on the top of the wall bracket; to measure the area of the swimming pool, manufacturer B needs to know the area of the vinyl liner.
