The pool body design of the hydraulic massage pool shall meet the following requirements
1. the hydraulic massage pool is a high edge pool, and a grid drainage ditch or skimmer shall be set along the outside of the pool wall.
2. the massage nozzle shall be set 200mm above the seat plate, and the nozzle spacing shall not be less than 800mm. For the pool with small area, the nozzle shall not be arranged relatively.
3. when the air pump is used for air supply, the round off of the air pump shall comply with the provisions of paragraph 3 above.
4. when natural air is used for air supply, the air inlet cap shall be in the form of adjustable air inlet volume with noise elimination measures. The air inlet cap shall be set at a place with good air environment. In order to prevent the pool water from flowing back, the air inlet cap shall be no less than 100mm higher than the pool water surface.
5. the water supply pipe and air supply pipe of massage nozzle shall be arranged in a ring to reduce the resistance, so as to ensure the consistency of water flow and water pressure of each nozzle.
6. when the normal temperature or warm water massage pool is built together with the swimming pool, the water supply pipe of the massage pool shall be connected from the circulating water supply pipe after purification treatment of the swimming pool.
