Potential safety hazards for swimming pool lighting
Waves will be generated when swimming, and the light will reflect and produce serious glare within the wave range. At the same time, when someone is in danger, due to the glare, it may not be found and cannot be rescued in time. The staff and service personnel must be able to clearly see the swimmer in danger, which can be achieved by limiting the reflected light on the water surface and having a standard level of illumination; TUONAS lighting fixtures are equipped with anti-glare controller and anti-overflow device, which can effectively reduce glare and guide the light source back to the swimming pool, prevent visual interference caused by light scattering. The rich light distribution can meet the needs of different lighting environments, and can reasonably select the installation location to avoid areas prone to glare.
The swimming pool is a particularly wet place for immersion. This kind of place is full of moisture and often has condensed water, which is easy to cause electric leakage or short circuit due to the reduction of lamp insulation level, and the human body impedance is also significantly reduced due to skin wetting, and the risk of electric shock is greatly increased. Therefore, the electrical equipment in such places should use a safe 12-24V low-voltage design, which conforms to the international standard of safety voltage lower than 36V, so as to ensure that the human body will not have a safety accident due to electric shock; TUONAS lighting fixtures adopt totally enclosed structure, with dustproof and waterproof grade of IP65. The exposure of wireless beam can effectively prevent the lamp from being damaged by electric leakage, electric shock and rust. In addition, honeycomb heat dissipation technology ensures the service life and stability of the lamp.
The wet, high temperature, salt fog and other environments of the swimming pool have higher requirements on the anti-corrosion, moisture-proof and anti-fog of lamps. The shell of TUONAS lighting lamps adopts hot-dip galvanized coating, which has high strength and strong impact resistance.
Basic requirements for swimming pool lighting
1. The minimum horizontal illumination at any point in the swimming pool shall not be less than 250lx;
2. Light should be able to refract into the water;
3. Avoid glare from direct or reflected light.
