Is the installation and construction of pre embedded parts for swimming pool underwater lights very complicated? Details are important!
The installation and construction of embedded underwater lights for embedded swimming pools are relatively complex, requiring attention to details at every step from determining the type, size, installation position, height, wall openings, to connecting the light body. The following are the installation steps and common precautions:
Determine the pre embedded parts for embedded swimming pool underwater lights: Design and select suitable pre embedded parts according to the type of swimming pool, such as civil engineering pool, adhesive film pool, fiberglass pool, steel structure adhesive film pool, etc. The pre embedded parts and accessories used may vary, and specific information can be obtained from lighting manufacturers or engineering vendors.
Determine the installation position and height of embedded underwater lights for the swimming pool: Based on the lighting design plan, determine the specific installation position and height of the embedded parts and mark the installation holes.
Swimming pool wall openings: If it is a civil swimming pool, first confirm the thickness of the concrete wall and customize the appropriate size with the lighting manufacturer in advance. Before pouring the wall, install and place the embedded parts at a suitable height. Pay attention to sealing and filling the embedded parts to prevent the pouring of cement mortar;
If it is a steel structure membrane swimming pool, suitable holes for embedded parts need to be opened in advance in the steel body. After assembling the steel body, apply adhesive film and make corresponding sized holes on the adhesive film before installing the embedded parts. The installation methods of different types of embedded parts are different. For specific details, please consult the lighting manufacturer or engineering contractor. Note that the screws of the embedded parts are difficult to tighten, and some lubricating oil can be added appropriately to prevent the screws from getting stuck.
Finally, connect the lamp body: After the embedded parts are fixed, install the lamp onto the embedded parts to ensure that the lamp is installed firmly and stably. Pay attention to reserving a 1.5-meter wire on the back of the lamp to facilitate the maintenance of the lamp body underwater in the future, so as not to drain the water in the swimming pool.
During the installation and construction process of embedded swimming pool underwater lights, attention should be paid to waterproof treatment to ensure that the connection between the lights and the embedded parts is well sealed to prevent water leakage. After installation, a comprehensive inspection and debugging work is required to ensure that the lighting fixtures can work properly and meet the design requirements.
